DOD SR606 Owner's Manual download pdf (Page 7)

SR606

DISTRIBUTION AMP

To use the SR606 as a distribution amp connect your source signal to either

the Left, Right, or Left and Right Inputs.

Connect as many of the 1 through 6 Outputs as desired.You may also use the

Left and Right Outputs for a total of 8 Outputs.

The signal coming in to the Left/Right Inputs will be delivered to the 1 through

6 Channel Outputs.

The Level control of each Channel will adjust the volume at each individual

Channel Output.

The Pan control of each Channel will select which Input (Left/Right) the signal

is being taken from.

The Master Output will only affect the signal strength at the Left/Right

Outputs.

In this mode the SR606 can be used as a mono in with six outputs, or a dual

mono in with as many outputs (up to 4 for each mono input) as you desire.

BUFFER AMP

To use the SR606 as a buffer amp, connect your source signals to as many of

the 6 Inputs as needed.

Connect as many of the 6 Outputs as needed.This should coincide with the

number of Inputs.

The Channel Level knobs will now attenuate, or provide up to a 4 dB boost in

gain to the signal(s) being sent to the corresponding Outputs.

MAINTENANCE AND SERVICING

There are NO user serviceable parts inside the units. Opening the chassis will

void the warranty. All service and repair must be performed by the factory or

an authorized service center for the warranty to remain in service.

Should a problem arise with the equalizer, please contact your authorized DOD

Electronics dealer for return/repair procedures.

1 2 3 4 5 6 7 8 9 10

No comments

DOD SR606 Owner's Manual Page 7